The short answer

“MEZZ” is a family nickname, not a single specification. Establish whether the putter is MEZZ.1 or MEZZ.1 MAX and verify its complete build.

There is no single generic “MEZZ putter”. L.A.B. Golf offers MEZZ.1 and the larger MEZZ.1 MAX, and each can appear in different build configurations. Identification comes before any meaningful comparison.

MEZZ.1 versus MEZZ.1 MAX

The manufacturer describes MEZZ.1 as a mid-mallet with a familiar winged outline. MEZZ.1 MAX has a larger footprint. Both use the company’s Lie Angle Balance concept, but size changes the view at address and may change a player’s sense of stability and pace.

Read the build, not the colour

Colour and alignment markings can vary. Confirm the model engraving, handedness, playing length, lie angle, grip and shaft. On a used example, ask whether the shaft has been cut, the grip replaced or the head altered. A listing that only says “MEZZ” is incomplete.

Compare the two shapes

Test whether each head sits naturally behind the ball and whether its alignment scheme agrees with your aim. Use short putts for starting direction and longer putts for pace. Larger does not automatically mean better; some golfers prefer the clearer outline of the smaller head.

Get the setup checked

L.A.B. Golf provides a remote fitting process for length and lie. An in-person putter fitting can also compare the MEZZ shapes with your present putter. For help identifying or measuring a putter in Randwick, contact Fix It Golf.

Example: an incomplete used listing

A listing headed “L.A.B. MEZZ 34 inch” still leaves important questions. Ask for the sole and model markings to distinguish MEZZ.1 from MAX, measure rather than accept the stated length, and request any known lie-angle record. Photograph the grip and shaft labels and ask about alterations. If the head proves to be the smaller model, the MEZZ.1 buying checklist is the next step. If it is the larger head, use the MEZZ.1 MAX comparison.

Decision checkpoint: When the seller cannot supply the lie angle, treat the club as an inspection candidate rather than a confirmed fit. Measure it before allowing a rare finish or low price to decide the purchase.

Back to the journal